Baumer IVO GmbH & Co. KG 03.10 • 171.51.278/2 Dauchinger Strasse 58-62 • DE-78056 Villingen-Schwenningen Irrtum sowie Änderungen in Phone +49 (0
NE230 10 www.baumer.com 3. Memory location readout All memory locations provided with a line number in the programming plan allow readout (except fo
NE230 www.baumer.com 11 4.1. Examples for programming memory locations For the example below the following settings do apply: device ID = 35; coun
NE230 12 www.baumer.com 5.3. Readout counter identification Identification data are read only. The counter identification is followed by two param
NE230 www.baumer.com 13 6. Error alarms in data transmission Upon receiving a wrong data protocol by PC (for example: not existing line or letters
NE230 14 www.baumer.com 8. Operating Plan line default customer i significance 01 0 XP – running value main counter 02 1
NE230 www.baumer.com 15 9. Programming plan Lines 11-17 status of lines 1-7 0 parameter to be altered 1 clear resp. input lock
NE230 16 www.baumer.com Line 37 activation of presets P1, P2 0 immediately active 1 after reset Line 38 counting rang
NE230 2 www.baumer.com Wichtig ! Die Leerstellen zwischen den einzelnen Zeichen in den Befehlen dienen nur zur besseren Darstellung. Die Eingabe a
NE230 www.baumer.com 3 Alle im RUN-Modus programmierten Daten werden erst nach einem Wechsel vom PGM-Modus in den RUN-Modus in den nichtflüchtigen
NE230 4 www.baumer.com Antwort: <STX>35P<ETX><CR> Eine Wiederholung des Befehls schaltet wieder in den R
NE230 www.baumer.com 5 6. Fehlermeldungen beim Datentransfer Wird vom PC ein falsches Datenprotokoll an den Zähler gesendet, (z.B.: Zeile, die nich
NE230 6 www.baumer.com 8. Bedienungsplan Zeile Werkseinstellung Kundenprogramm Kurzbeschreibung 01 0 XP - Zählerstand Hauptzä
NE230 www.baumer.com 7 9. Programmierplan Zl 11-17 Status für Zeile 1-7 0 Parameter kann geändert werden 1 Löschen bzw. Eingabe ges
NE230 8 www.baumer.com Zeile 37 Übernahme der Vorwahlen P1,P2 0 Sofort wirksam 1 Bei Rückstellung Zeile 38 Einstellbere
NE230 www.baumer.com 9 Operating instructions Interface description NE230 Program 01 1. General information The serial interface has the same func
Comments to this Manuals